Since 1969

Case Neck Graphiter

Forster # 011341 |  Item # 070-011341
  • Case Neck Graphiter
  • forster-reloading
$16.99
Quantity
Status: In Stock

DESCRIPTION

Case Neck Graphiter
by FORSTER


Product Overview:

When sizing a fired case, pulling the expander button through the case can present a problem because residual deposits left from firing can create friction when the expander is withdrawn. In a worst case scenario, that friction can cause distortion or stretching of the case neck. Properly lubricating the inside diameter of your case necks is the answer, but oils are not recommended because of the possibility of gunpowder contamination.

By moving the case neck up and down on the correct graphite-covered brush, the inner diameter (ID) of the neck can be cleaned and lubricated at the same time.

The Forster Case Graphiter is constructed of tough, impact-resistant plastic, and the base is drilled to permit permanent mounting to a loading bench. Three brushes are mounted in the base. They accommodate all calibers from .22 to .35. The Case Neck Graphiter is supplied with adequate white motor mica to process 2,000 to 3,000 cases. A cover is included to prevent dust and grit from contaminating the powder.

Was this information helpful?

  • Shipping Weight: 0.14lbs. - Please Note: Most packages will require extra packing materials.
There are no special offers for this product at this time.
No manufacturer information available.